-11% 15 Inch x 3 Inch HydraMat, Rectangle, 11mm Inlet (Straight)

This Hydramat is designed to fit on the 11mm inlet found on many Walbro / TI Automotive Fuel Pumps, including the following:

  • GSS341 and GSS342 255 LPH pumps
  • F20000312 and F20000313 255 LPH pumps
  • F90000262 and F90000273 400 LPH Pumps
  • F90000267 and F90000274 450LPH pumps

The fitting positions the Hydramat at 90 degrees to the pump, placing it horizontal if the pump itself is positioned vertically.  If you need a hydramat for your Walbro / TI Automotive Fuel Pump that will allow you to lay the pump at an angle then consider the 16-116.

Hydramat is compatible with all gasoline blends (Alcohol, Ethanol, Methanol, and E-85). Hydramt is not to be used with with oils, diesel fuels, or any other fluids. It acts as a fuel pump pre-filter, providing 15 microns of filtration capacity, so no filter is required between the Hydramat and the fuel pump. Hydramat cannot be cleaned, but should provide a life expectancy of between 5 and 10 years under normal use and with care to only use uncontaminated fuel.

Not Sure? Review this product documentation before you buy!

 
Installation Guide
Holley Hydramat Installation Notes

Fluid Fittings
Fittings IncludedNo
Outlet Size11mm Female; Straight; Suited to Walbro / TI Automotive pumps with 11mm male inlet
Fuel Filters
Filter TypePre-Filter
Hydramat
Connector LocationCenter-Offset
Filtration Level15 Micron
ShapeRectangle
General
ApplicationUniversal. Alcohol, Ethanol, Methanol, and E-85 fuels. Works with 2-cycle oil blends as high as 20:1
Emission Code3
Length15 Inches
OEM ReplacementNo
Unit of SaleEach
Width3 Inches

Write a review

Note: HTML is not translated!
    Bad           Good

15 Inch x 3 Inch HydraMat, Rectangle, 11mm Inlet (Straight)

  • Views: 26108
  • Brand: Holley
  • Product Code: 16-111
  • Availability: In Stock
  • $256.95
  • $227.95
Loading...